5 Soltutions To Skytech Fireplace Remote Not Working 

skytech fireplace remote not working
skytech fireplace remote not working

Skytech Fireplace remote is an affordable device that helps users better manage their heating units. Users can benefit from the timer and other features built into this unit to save cost while getting optimal performance from the system. So, setting aside a few dollars to purchase this remote will save you a lot of money in the long run. On top of that, you will have more control over the heating units in your home.

With that said, some users did mention issues with the Skytech remote not working. If you’re in a similar situation and the Skytech remote won’t work properly, then the following list of solutions should help.

How To Fix Skytech Fireplace Remote Not Working?

  1. Check Receiver Box

In most situations, the issue with the Skytech Fireplace remote not working can be traced back to problems with the receiver box. If you’re lucky, then simply securing the wiring connections properly should help you get ahead of this problem. All you need to make sure is that the wiring is tightened into place and there are no loose sections. Otherwise, the remote will keep running into issues.

Once the wiring has been secured, just turn on the slider on the receiver, and your heating system should come on. This will indicate that the system is working properly, and the remote will start working after the wiring is fixed.

  1. Install New Batteries

The issue with the Fireplace remote can also be linked to drained batteries and corroded terminals in the unit. So, if you have not replaced the batteries in a long time, it might be a good idea to get a fresh pair of batteries for your remote and install those in your system. Everything should start working perfectly after that.

If there is corrosion on the terminals or the battery holders seem out of place, then you need to clean it with any cleaner from the market and fix the orientation of the holders. Otherwise, you’ll struggle to manage power issues in the remote.

  1. Sync Remote

While there can be other issues like a defective receiver, sometimes simple syncing problems with the remote can point towards performance issues. So, if you’re sure that the fireplace and the receiver are working perfectly and there is sufficient power in your unit, then it is a good idea to sync the system again.

You can press and release the learn button on your receiver and the mode button on your remote to get through the syncing process. It only takes a few seconds, and you’ll hear a beeping noise from the unit that will confirm that your system has successfully synced with the remote. After that, you can go through the commands and the timer features on your remote to verify the performance.

  1. Reset Unit

If you’re still stuck in the same situation and you’re sure that there are no power issues with your remote, then the best thing you can do is reset the remote. This process is quite simple, and you just have to hold down the learn button for around 20 seconds.

After 20 seconds, your system will reset, and several beeps will start coming from the system. These beeps mark the end of the reset procedure and if you didn’t hear any beeps, then make sure to repeat the reset process. Once the device has reset, you can try syncing the remote again. It should work without further problems.

  1. Call Support

Depending upon your warranty status, it is always a good option to reach out to customer support regarding all of these issues. They will help you isolate the problem, and you won’t have to waste hours on the troubleshooting process mindlessly. So, just call the company number or your dealer about this issue, and they will help you get ahead of this problem.

Once the issue has been identified, go through the troubleshooting instructions offered by these experts. All in all, these are a few things you need to keep in mind if your Fireplace remote is not working perfectly. In most situations, you will just be dealing with power issues and syncing problems. So, just reset the controller and fix the battery connections to get ahead of the performance issues.

Leave a Comment