The Shark Vacmop is easy to assemble and configure, and you’ll enjoy an amazing cleaning performance from this robot. The price point is pretty reasonable, and you won’t have to go over budget with this option. However, a common issue that many customers mention about the Shark Vacmop relates to the robot not spraying any liquid before mopping the floor.
Usually, this is caused by an empty solution bin, but there is a chance that the outlet is blogged. So, you’ll have to thoroughly check the Vacmop to narrow down this issue. Here are some fixes to help you along your troubleshooting journey with Shark Vacmop.
How To Fix Shark Vacmop Robot Not Spraying?
- Add More Solution
You should always check the solution level in the unit when it is not spraying, as there is a good chance that your device has run out of liquid. Even though the compartment is pretty massive compared to the size of the robot, you will still need to add more solutions after one or two cleaning cycles. So, when the spray stops, add more solutions to your unit and then check the performance of the machine.
Some owners also mentioned that slightly diluting the solution helped them with better results. So, if you’re not getting anywhere with adding more solutions to the device, just dilute it a bit and check the performance of the machine one more time. Hopefully, you won’t be disappointed by the results.
- Clean Up Outlet
Sometimes, it is the outlet that is clogged up, and you have to clean up the unit to make sure nothing is blocking the spray from coming out of the robot. Ideally, you should be cleaning the robot every day, but if it has been more than a week, you’re likely running into this issue because of a clogged outlet.
The only thing to do here is to thoroughly clean the robot and make sure that there isn’t any debris stuck at the bottom of the unit. That should be enough to get everything in order.
- Check Charging Status
After that, you should also check the charging status on your unit, as the low charge will impact the mopping performance. So, if the spray stops working, you should just dock the robot for a few hours and then start the cleaning cycle again.
The spray will work only when the unit is properly charged, and it won’t respond well to low battery levels. For this reason, you should set the cleaning cycles accordingly to avoid low battery levels and sufficient charging time for your Shark Vacmop.
- Reset Schedule
At this point, you need to reset the schedule or update it slightly to refresh the routine. Just bump up the cleaning cycle by a few minutes and then check the response from your robot. It won’t take up much of your time to set up the new schedule, and you can check the spraying performance over the next couple of cleaning rounds. Hopefully, that would be it when it comes to spraying issues with your Shark Vacmop.
- Empty The Dirt Chamber
When you’ve not emptied the dirt chamber for too long, the spray will stop working. So, if you haven’t had time to clean or empty the dirt chamber, make sure to do it now and then check the solution levels on your unit. Top up the solution and then start one more cleaning cycle. This time around, the robot should spray the floor, and you won’t have to worry about any more steps.
- Reset Your Vacmop
There is always the option of factory resetting the smart robot when it is not responding to spray commands. You might be in possession of a defective unit, and the only logical thing that can be done here is to reset it to factory settings. So, just wipe away all the configurations and then start from scratch.
Overall, the issue with the Shark Vacmop not spraying is mostly related to low solution levels. However, there is always a chance that you have a defective unit, and you should involve the experts from Shark customer support if that is the case. You won’t be able to fix the unit yourself, and these experts will guide you through the warranty-claiming process.