A motion sensor helps open up a whole lot of opportunities in your smart home. Not only can it be used for security purposes, but you can also use these sensors to save energy inside the house.
However, there can be times when you will notice facing issues with such devices. With that said, users who were using the Leviton motion sensor have been found complaining about the sensor as it does not turn off.
For this purpose, we will be listing all the possible troubleshooting steps that can be used to fix this. So, let’s get started!
How to Fix Leviton Motion Sensor Does Not Turn Off?
- Checking the Wires
Whenever you notice your sensors acting up, the first thing that you should check is if the wires are properly secured in their place. Most of the time, what usually happens is that there is some sort of broken or loose connection between the sensor and the device.
In either case, you will have to try physically inspecting the wiring for anything that might be out of place. If you do notice any broken or loose connection, you will have to apply repairs accordingly. It could be that the ground isn’t connected to any fixture because of which your sensor isn’t turning off.
- Inspecting the Light Fixture
Apart from the wiring, another thing that needs to be checked is the light fixture itself. If you are using the motion sensor with any such devices, then there’s a good chance that you might have messed up the process.
Anyhow, it is worth checking the fixture and making sure that everything is indeed in order. If not, then you will have to try referring to a manual guide to understand how you can use the motion sensor with your fixture.
- Poor Installation
The most common reason why you are bound to face issues with your sensor is simply that you have missed out on something while installing it. More specifically, you could have used an incorrect procedure to set up the 3-way switch as it needs a jumper wire.
Though before you do anything, you must refer to the user manual guide as it should have all the instructions that you will need to help you be able to install the sensor.
- Getting it Checked
For those of you who seem to be struggling while trying to install these motion sensors, it is strongly advised that you try seeking professional help instead. You should be able to call in a technician at the house and let him have a look at it.
Similarly, after thoroughly inspecting the motion sensor and the wiring, he should be able to figure out the reason why your sensor’s not turning off along with what needs to be fixed. On top of that, he should be able to apply the repair himself.
Besides this, you can also try getting in touch with the support team. They should be able to advise you on further troubleshooting instructions that you can follow.
- Broken Sensor
If you still haven’t had any luck in resolving the issue, then it would be safer to assume that you have a faulty sensor device. In such cases, there is nothing you can do to repair a broken sensor. However, you can still get a full replacement unit.
Especially if your unit is still under warranty, you should easily be able to get a replacement unit sent out to you without any extra cost.
The Bottom Line:
Frustrated with Leviton motion sensor does not turn off? Typically, these types of errors occur when there is an issue with how you have the sensors installed. So, be sure to check the wiring as well as the circuit to ensure that you have everything in order. Still, if the issue persists, then try following the instructions that we have mentioned above.