The Leviton switches have been dominating the market with their energy-efficient and convenient units that help users keep their electricity bills under control. These devices are pretty advanced, and you will always have complete control over your appliances and lighting with units like Leviton IPS02.
However, it is not all sunshine and rainbows, and you will have to deal with several performance-related issues with the switch.
Almost all of these issues will be related to a poor installation, and you will have to go over a variety of factors to get the devices working again.
So, here are some solutions that can help you fix the Leviton IPS02 unit.
What To Do When The Leviton IPS02 Is Not Working
- Check Ground Connection
The ground connection is the first thing that you need to check when this motion detection switch is not responding. While many users believe that they don’t have to install a ground connection with this model, experts from the Leviton support have underscored the importance of a ground connection time and time again.
So, you will have to check for the ground connection in the wall mount.
Make sure that the ground connection is properly connected with the wiring system, and then check the response from the switch again. Hopefully, your system will start working perfectly, and you won’t have to bother with the same issues again.
- Manage Motion Sensing Range
If you’re sure that the switch has access to power, then you need to look at the motion detection configurations to isolate the issue. Most of the time, you will be too far out of the range, and the range of the motion detection features won’t be able to register your input. So, you just have to move closer to the unit or find a better spot for the switch if it is not working.
It can be a bit annoying to deal with, but there is nothing you can do when you’re outside the range of the motion detection range. So, make sure to bridge the gap by a little margin and then check the response from the unit.
- Check Lighting Configurations
Sometimes, you’ll just be dealing with insufficient lighting adjustment when the motion is detected. So, if you’re sure that the input is getting registered, then simply adjust the lighting levels and try out the motion detection features again. Hopefully, this time around, the light will turn on without further issues with the system.
- Go Through Timer Delays
There have also been a few reports where the timer delays weren’t set correctly by the users. The timer on your Leviton IPS02 ultimately dictates the performance of this switch. If the timer is not set correctly, then the lights won’t come on or go off after motion has been detected by the switch.
So, make sure to reduce the timer by a significant margin and then test out the performance of the lighting system again. This will get your device working perfectly, and you will be able to get the desired performance from your lighting system.
- Fix Power Connections
If the switch is unresponsive and you’re sure that the light connected to the switch is in good shape, then you need to isolate this issue to a defective wiring connection. There is a chance that you’re dealing with a loose connection or a corroded point. So, make sure to isolate the issue with the Leviton switch not working to a damaged wiring setup. This will help you get the desired performance from the switch, and the unit will start working perfectly after you replace the damaged wires.
- Make Sure Your Lights Are In Good Shape
On the other hand, if you’re not sure about the condition of your lights and the switch was working perfectly just a few days ago, then you need to replace the bulb. There is a decent possibility that you’re dealing with a defective bulb, and you will have to install a fresh unit.
Luckily, new lights aren’t that expensive, and you won’t have to bother with the configurations again. So, simply check the condition of the lights as well as the fixture if you’re sure that the Leviton IPS02 is in good condition. Hopefully, the issue will be fixed at this stage.