The Lefant Robot Vacuum will keep you updated with any and all issues by flashing a red signal and sounding various beeping routines. You can narrow down the actual issue with the robot pretty easily by keeping track of the beeping frequency, and you won’t have to waste as much time trying to isolate the problem. Most of the time, the blinking red light on the Lefant Robot Vacuum relates to improper charging or placement.
So, if you’re in a similar situation where the robot won’t stop flashing red light and you can hear beeping from the unit, then go through some of the following troubleshooting methods. Hopefully, you won’t have to spend hours trying to fix your machine.
Fixing Lefant Robot Vacuum Blinking Red Light
- Turn On Robot While Charging
The most common issue with the blinking red light is that the robot is turned off as you’re trying to charge the machine. This cleaning unit won’t be able to charge properly when it is turned off. So, if you get the blinking light issue as soon as you place the robot on the docking station, try turning it on for a few minutes. That should be enough to help you with the blinking light issue in the Lefant Robot vacuum.
- Move To Even Ground
Sometimes, it is not that charging status but rather the placement of the robot on a rough patch of ground. This device is pretty efficient as far as the cleaning performance is concerned, but you will still need to find a stable and even piece of floor to get this robot to work. So, if the robot is beeping twice or thrice in succession, make sure to check the working region. There is nothing that you can do about this situation except to repair the cleaning patch.
- Clean Up Dustbin
If you’ve not cleaned up the dustbin in a while, then that might also be at fault here. You need to make sure that the dustbin is emptied out after every cleaning cycle, and that should be enough to get rid of the blinking light issue.
- Check Charging Points
At this stage, you need to check the charging point on your cleaning robot for debris. If there are issues with the power flow from the docking station to the robot, this unit will start flashing the red light. Luckily, you can easily avoid this issue by cleaning the connection points and then fixing the alignment of the cleaning robot on the docking station. You can also try to use a different outlet to fix the issues with the power flow.
- Reset The Cleaning Robot
There is always a possibility that you’re dealing with a minor programming bug that can be fixed by a quick power cycle. So, turn off the robot completely and then turn it on after a few seconds. If the issue is not that serious, the robot should power up at this point. However, you might need to go through the reset routine if the issue persists at this stage. It will take a few minutes for the robot to reset, but hopefully, you won’t have to deal with the same complications again.
- The Robot Might Be Damaged
The robot might also be damaged at this point, and you need to check the condition of the sensors along with the base to isolate the issue. If you can see cracks on the base, then the robot is likely damaged, and your best bet is to take it to a repair center. On the other hand, if you’re sitting on a valid warranty, seeking help from the dealer is not that bad of an option. So, reach out to customer support and inquire about this issue further.
- Check For Obstructions
The issue might just be related to obstructions or clogged hair in the brush and wheels. So, flip the robot over and check the wheels for any movement issues. Make sure that the wheels can rotate freely and that there is nothing stopping the brush from cleaning the floor. Ideally, the issue with your Lefant robot vacuum not cleaning should be fixed at this point, but you can further isolate the problem by calling someone from the official customer support.
I have a error message saying “check if wheels are not on the floor” but they are. How can I solve this issue?