The main use of a light bulb is to help illuminate a certain area in the house. Compared to the traditional light bulb, a fluorescent bulb covers a much larger area and is usually a whole lot brighter. As a result, many people actually prefer using fluorescent bulbs.
Unfortunately, some people have been complaining about the internet after having their fluorescent bulb not getting bright enough. If you are also someone who is facing a similar problem, then keep on reading! We will be listing some of the most common reasons why this could be happening and what you can do in order to fix it!
Fixing Fluorescent Light Not Bright
- Not Getting Enough Power
One of the first reasons why you could be facing this issue could be because of electrical power issues. For instance, you could not be getting enough power to your light bulb due to which it might not be lighting enough.
We recommend checking the power source and ensuring that you are getting the correct voltage. While you are at it, we also suggest that you check the power fuses and make sure that it isn’t fused.
- Checking the Bulb
Another thing that you will need to check in case you are not getting a fully lit bulb is whether you have a dead bulb. There are a number of ways how you can check for a dead bulb. For starters, you can try replacing the bulb.
If you see any other bulb working just fine with the socket, then it is highly likely that you are in need of a new bulb inside your fluorescent tube.
- Testing the Electrodes
An electrode is an important component inside the fluorescent bulb which can be found inside the very end of the tube. Each tube should have two different pins that fit inside the sockets on either one of the ends.
To check the electrode, you will have to check for continuity through the pins. If you don’t notice anything, then it is highly likely that you are having trouble with the electrodes.
- Checking the Ballast
Most individuals who were previously facing the problem reported that the ballast was actually the component that was causing the issue to surface. If that is so, then luckily, the component can be changed quite easily.
To replace a ballast, you will have to remove the original one. Before you do so, make sure that you have turned off the power. One thing to note here is that you will have to get the ballast which is supported by your tube light. As it comes in different sizes, make sure that you get the right one.
Alternatively, you can also try getting your tube light to any local repair shop.
- Getting a New Fixture
If you haven’t had any luck so far, then it is highly likely that the whole fluorescent bulb is faulty. While you can still try getting it repaired, we don’t really recommend it unless you really have to. Instead, what you can do is to get a whole replacement.
Even if it does cost you a few bucks, it shouldn’t be that much. On the bright side, you should be able to get rid of any other potential problems that you might find on the way.
The Bottom Line:
Facing trouble with the fluorescent bulb not being bright enough? This is a pretty common issue that many people run into. Fortunately, in most cases, the problem can be easily resolved through applying a few troubleshooting steps.
So, if you are one of these users, then we strongly advise following the instructions that we have mentioned above in the article. Also, in case you seem to be confused at some point, be sure to leave down a comment below! We will be sure to reach out to you as soon as possible!
Replaced ballast (KTEB-240-1-TP/B)Keystone new ballast KTEB-240-1-TP/C. 2 tube 40 watt but lights are dimmer using same bulbs. Could the difference be the C versus B?
I have replace my two fluorescent tubes, not getting full light before old tubes burned out. One of the tubes fell out of my hand, did not bust up but one of the pins has been bent slightly. Could that be my problem?