Unlike other units on the market, you will get a dual filter system from the Myair unit. This device is known for its phenomenal purifying quality, and there aren’t many units that can outperform Bissell Myair, even if you browse through premium units like Blueair. So, if you’re looking for a decent machine that will last you for a few months, going with a Bissell Myair purifier is not a bad idea.
This unit will help you track the maintenance requirements with ease. So, you will know it is time to change the filter when the Bissell Myair Filter light starts blinking. However, if the issue persists, just follow through with some of these fixes.
Fixing Bissell Myair Filter Light Blinking
- Clean Compartment
The first thing that you need to consider is the filter compartment. Some debris or lint might be stuck in the compartment, and you will have to remove all the extra debris to unclog the system. It will take a few minutes of your time, but the light should stop blinking once the compartment is clean and the filters are in fresh condition.
- Check Alignment
If you’re sure that there is nothing clogging up the system, then you need to isolate this issue with the alignment of the filter. You won’t be able to get any cleaning done when the filters are not aligned relative to the bottom cover. So, keep track of the arrows and then adjust the alignment of the filter one more time.
Ideally, taking out the filters and then placing them back again should address this issue. So, if the light won’t stop blinking, just remove the filter and then attach them again one more time. That should usually be enough to fix this condition with the Bissell Myair filter light blinking.
- Power Cycle Your Unit
Power cycling the unit should be your next move, as this problem with the Bissell purifier might just be a minor bug. So, you need to narrow down the problem by power cycling the unit completely. All you have to do is to remove power from the system for around 60 seconds and then power it up again. This should refresh your unit, and you won’t have to bother with the same errors again.
- Check For Hardware Damage
At this point, the possibility of hardware issues increases by a decent margin. If your device is in rough shape, then the issue might not be related to the programming of your system. You should thoroughly inspect the purifier by taking apart its components and then check the response from your device. If the hardware is indeed damaged, the only option is to forward a warranty claim.
However, if the warranty has expired, the next best thing is to take the purifier to your nearest Bissell-approved repair center. They will help you figure out and isolate the problem with the purifier while guiding you through more fixes.
- Go Through A Factory Reset
On the other hand, if the device is in good shape, you need to isolate the issue to minor programming bugs. Resetting the device might wipe away all settings, but it is a surefire method of fixing minor issues with the unit software. So, all you have to do is to go through a factory reset routine and then set up the entire system one more time.
Keep in mind that this won’t help you if the filters are dirty, and there is no method that can help you avoid installing a replacement. So, go through a factory reset routine and then set up your system one more time. Hopefully, that will be it when it comes to the blinking light issues related to the filter.
- Seek Help From Official Bissell Support
Ideally, you should be changing the filter every 8 to 10 weeks. However, the frequency of a filter replacement depends entirely upon the surroundings. If the air is dirty, you will have to change the filter frequently. There is no point in taking the filters out and rinsing them out for reuse. It will only damage the unit, and you should always get fresh filters. However, if the issue persists even after you’ve correctly followed through with these steps, ring up customer support for assistance.