This universal remote might seem a bit out of budget, but the convergence and accessibility features justify the price tag. If you have a variety of smart home devices installed in your home, then sticking with Harmony remote will help you centralize controls through a single unit. So, if you have the budget and need something to increase your control over the smart system installed in your home, then sticking with the Harmony remote is your best bet.
With that said, there have been some reports on Harmony remote not switching inputs. If you’re in a similar situation and the Harmony remote is not giving the desired performance then the following solutions might help.
Ways To Fix Harmony Remote Not Switching Inputs
- Check Commands
Most of the time, this issue with the Harmony remote can be traced back to improper commands on the unit. So, there is a good chance you’re struggling with a similar situation. All you need to do is access the command configurations on your desktop software and assign the single or multiple commands again. This should eliminate issues with the Harmony remote not switching inputs.
You can also try different variations of the common commands to switch input from the remote. So, try to use the input next or the next input options, and as long as you’re on a single command setup, it should change the input from your Harmony remote. Ideally, the issue will be fixed at this stage, and you won’t have to bother with any more steps.
- Check Model
There have been a few reports where users mentioned that they were running into issues because of the wrong unit model in the device configurations. So, even if the commands on your system are perfect, there is a chance that you will run into these issues if the model of the device is not managed properly on the remote configurations.
This issue is also pretty common for users with older units. If you’re using an old TV then there is a chance that you will be struggling with the model because of compatibility issues. In this situation, switching to another model should eliminate the issue, but you can always try to contact the support team regarding compatibility problems. That way, you won’t have to spend as much time isolating the issue with your Harmony remote.
- Adjust Delay
Adjusting delay on your remote also has a positive impact on helping users sort out the issues with Harmony remote not switching inputs. While many people believe that decreasing the delay will ensure the users with more performance, it can lead to a variety of issues when it comes to executing commands. So, if you’re also minimized the delay on your Harmony remote, then that is likely why you are running into issues with switching inputs.
To get ahead of this problem, all you need to do is access the device configurations and increase the delay. Around five to ten seconds of increment in the delay should be enough to fix these input issues. However, there have been a few users that mentioned they were able to get ahead of this problem by increasing it by a margin of 20 seconds. So, you should follow a similar method, and the issue with your unit will be fixed.
- Alter Sequence
The sequence of commands on your system can also play a role in the issue related to switching input. So, if none of the solutions mentioned above are helping you with the problem, then altering the sequence might just be the solution you need to fix this issue. All you need to do is randomize the execution of the command sequence and that should be enough to get ahead of this situation.
With that said, you can also directly contact the professional support members regarding this problem. Reaching out to these experts will help you save a lot of time in the troubleshooting process. So, if you’re not getting any success with switching inputs even after altering the sequence, then calling these experts is your only option. They will help you narrow down on the cause of this issue, and you’ll be ahead of this problem in no time. Hopefully, this information will help you fix your universal remote.